Page 4 of the default display can only be used if one of the two special connection types (A,G2,C,G; G->B
or A,G2,C,G; G2->B) was selected for the current transformer connection (parameter 251 CT Connect.)
(see description of the Power System Data 1).
for the Graphic Display of 7SJ613 and 7SJ614
[grundbild-sj61-grafikdisplay-020313-kn, 1, en_US]
Figure E-3
Default displays of the graphic display
Spontaneous Fault Indication
After occurrence of a fault, the most important fault data appear in the display automatically in the sequence
shown below, without further operating actions.
[7sj61-spontanmeld-display-20070427, 1, en_US]
Figure E-4 Display of spontaneous annunciations in the 4-line display of the device
Default Settings and Protocol-dependent Functions
E.5 Default Display
SIPROTEC 4, 7SJ61, Manual 379
C53000-G1140-C210-6, Edition 05.2016
To Next Page
Loading...
