Default Display
In devices with 4-line displays and depending on the device version, a number of predefined measured value
pages are available. The start page of the default display appearing after startup of the device can be selected
in the device data via parameter 640 Start image DD.
Devices with graphic display feature a default display which shows the present operating state and/or selected
measured values. The display size is selected during configuration.
for the 4-line Display of 7SJ61
[grundbild-sj61-ohne-erweiterung-291003-kn, 1, en_US]
Figure E-1 Default display for configuration without extended measured values (13th position of MLFB =
1)
Page 3 of the default display can only be used if one of the two special connection types (A,G2,C,G; G->B
or A,G2,C,G; G2->B) was selected for the current transformer connection (parameter 251 CT Connect.)
(see description of the Power System Data 1).
[grundbild-7sj61-mit-erweiterung-2o3-060627, 1, en_US]
Figure E-2 Default display for models with extended measured values (13th digit of MLFB=3)
E.5
Default Settings and Protocol-dependent Functions
E.5 Default Display
378 SIPROTEC 4, 7SJ61, Manual
C53000-G1140-C210-6, Edition 05.2016
To Next Page
Loading...
