11.4 Diagnostics
Power-up
Explanation DEVICE OUT IN SF
Hardware test
Note: Input expansions remain in this state until acknowl‐
edged by the device on the right-hand side.
Green Green Green Green
The SET/RESET button is stuck, or has been pressed too long.
The device remains in this state until the button is released
again.
Green ashing Green ashing Green ashing Green ashing
Display of DIP switch conguration. If the DIP switch position is at ON (right), the relevant LED shows
a yellow light.
Conguration
Explanation DEVICE OUT IN SF
Indication of a modied conguration. If the DIP switch position is at ON (right), the relevant LED ash‐
es yellow
Special conguration, two-hand operation
NC/NO, autostart, 2 x single-channel.
O If the DIP
switch posi‐
tion is at ON
(right), the rel‐
evant LED
ashes yellow
Flickering yel‐
low
If the DIP
switch posi‐
tion is at ON
(right), the rel‐
evant LED
ashes yellow
Impermissible conguration
NC/NO, monitored start, 2 x single-channel
Yellow ash‐
ing
If the DIP
switch posi‐
tion is at ON
(right), the rel‐
evant LED
ashes yellow
Flickering red If the DIP
switch posi‐
tion is at ON
(right), the rel‐
evant LED
ashes yellow
All DIP switches are in OFF position (left) All LEDs light up briey (yellow) at intervals
Safety mode
Explanation DEVICE OUT IN SF
No startup testing. Green ashing O O O
Device ready for operation, all outputs OFF. Green O O O
Device ready for operation, all outputs ON. Green Green Green O
Device ready for operation, instantaneous outputs OFF,
time-delayed outputs ON.
Green Green/yellow
ashing
O O
If "monitored start": START button not yet pressed. Green O Green ashing O
With input expansion: Missing enabling signal of input ex‐
pansion.
Green O Yellow ash‐
ing
O
Conguration has been changed (PAR, DIP switch, potenti‐
ometer)
Green/yellow
ashing
—
1)
—
1)
—
1)
Display and diagnostics
11.4 Diagnostics
SIRIUS 3SK1 Safety Relays and 3RQ1 Positively-Driven Coupling Relays
Equipment Manual, 05/2021, A5E02526190021A/RS-AE/005 189