Mounting/removing
5.3 SITOP UPS1100
SITOP UPS1600 / BAT1600 / UPS1100
196 Equipment Manual, 07.2021, A5E37775406-11-76
Note
When shipped by air, as a result of transport regulations for hazardous goods, when
requested, SITOP BAT1600LiFePO4 battery modules are only charged up to 30
% in the
factory. Always fully charge the batteries before storing for a long period of time. When
supplied, LiFePO4 batteries are internally disconnected, and therefore must first be
connected before charging.
Removal
To remove the device, pull it downwards while removing it from the lower edge of the DIN
rail (see Figure 5-9 Removal (example 6EP4133-0GB00-0AY0 (3,2 Ah)) (Page 196)). Then you
can remove the device from the upper edge of the DIN rail.
Figure 5-9 Removal (example 6EP4133-0GB00-0AY0 (3,2 Ah))
To Next Page
Loading...
