Siemens SITRANS FUS380 - Page 36

3. Connect output cable(s).
([WHUQDOFRQQHFWLRQ
&RQQHFWLRQ9DULDQW
3DVVLYHRXWSXW
2SHQGUDLQ



2XWSXW$
2XWSXW%
3RVLWLYHORJLF




5

5

9ื9'&

9




9
9
9
,P$

,P$

9ื9'&



6LJQDO
6LJQDO
4. Tighten cable gland for output cable(s) (approx. 20 Nm).
Note
Cables with voltage
Keep the output signal cable(s) separated from cables with voltages > 60 V.
Note
Ingress protection
To guarantee the IP67 (NEMA 4X/6) degree of protection, use cables with the required
specifications.
Note
Protected terminal
The wire size for the mains-powered terminals are AWG24 to AWG16 or 0.205 mm
2
to
1.500 mm
2
.
Note
EMC performance
Incorrect fixing of the output cable shield will affect the EMC performance.
Note
Optional current output module
If you want to install the optional current output module, proceed with chapter Installing and
connecting optional current output module (Page 44) before mounting the transmitter.
Connecting
5.3 Compact system
SITRANS FUS380/FUE380
36 Operating Instructions, 05/2018, A5E00730100-AE