Load the parameters to the device by clicking on . Check the option [Load changed
parameters only] to speed up the communication and avoid errors.
For overview of the parameters see Parameter lists.
6.5.5 Optimizing the system
After storage of the settings, the parameters can be set according to use.
The following shows how to set Pulse Output A and Qmax. For other parameters, refer to
"Parameter list" in the appendix.
Commissioning
6.5 Commissioning via PDM
SITRANS FUS380/FUE380
58 Operating Instructions, 05/2018, A5E00730100-AE
To Next Page
Loading...
