Installing
1. Remove transmitter/terminal box lid.
2. Carefully mount current output module on the eight pins.
3. Fasten module to transmitter connection board by use of a M3x5 screw (0.5 Nm).
CAUTION
Protective earth
The M3x5 screw also functions as earth conductor (EMC).
See also
Optional current output module (Page 89)
5.5.2 Connecting
The output terminals are marked 31 and 32 with corresponding polarity + and - on the terminal
strip. The connector
is for shielding.
The requirements for the current output cable, for example max. load can be found in
AUTOHOTSPOT.
1. Replace blind plug with cable gland (if two output signals are required, use a double entry
cable gland).
2. Push output cable through open gland.
Connecting
5.5 Optional current output module
SITRANS FUS380/FUE380
Operating Instructions, 05/2018, A5E00730100-AE 45
To Next Page
Loading...
