Siemens SITRANS FUS380 - Commissioning Via PDM

After ten seconds the message reset.bat will appear.
1. Press push button within six seconds to reset the internal battery counter. The
message accept will appear.
2. Press push button again within six seconds in order to reset the internal battery counter.
The battery indicator now shows . If the push button is not pressed again, the battery
indicator will show .
/


Figure 6-2 Reset internal battery counter
* Firmware version
6.5 Commissioning via PDM
SIMATIC PDM (Process Device Manager) is a software package for configuring,
parameterizing, commissioning, and maintaining field devices.
Among other features, SIMATIC PDM contains a simple process for monitoring process
values, interrupts and status/diagnosis signals of a field device.
Note
For instructions on installation and operation of SIMATIC PDM, refer to the SIMATIC PDM
Getting Started (included in the documentation package that comes with PDM).
Note
PDM requirements
Minimum PDM version required is SIMATIC PDM V8.2 + SP1. The required operating system
to install SIMATIC PDM is Windows 7.
Note
Default password
Any data changes in PDM require a password. The default password is 1000. For further
information, see Password-protected data (Page 66).
Commissioning
6.5 Commissioning via PDM
SITRANS FUS380/FUE380
52 Operating Instructions, 05/2018, A5E00730100-AE