Commissioning
6
6.1 Introduction
Commissioning the device includes the following steps:
1. Resetting the battery lifetime (see Start-up routine (Page 51)).
2. Checking values in the service menu.
3. Configuring the device via SIMATIC PDM (see Commissioning via PDM (Page 52)).
Before commissioning, a basic guide to the local display and the menu structure is offered in
the chapters: Operating the local display (Page 49) and Navigating the menu structure
(Page 50).
6.2 Operating the local display
The local display is divided into 3 areas:
● Top area with symbols for status information
● Mid area with actual readings
● Lower area with index number of the shown menu or the service menu symbol ( ).
Activate the push button to go the next index menu and related information. The service menu
is accessible from all menus by pressing the push button for minimum 2 seconds.
Figure 6-1 Operating the local display
Table 6-1 Status information symbols
Symbol Description
Mains power supply connected
Battery charge status
Warning
Service menu
SITRANS FUS380/FUE380
Operating Instructions, 05/2018, A5E00730100-AE 49
To Next Page
Loading...
