5.3.5 Finishing connection
Mount the transmitter.
Note
Grounding
To ensure identical potential for sensor and transmitter, a direct grounding of transmitter and
sensor is recommended.
Note
Aligning the gasket
Please ensure that the gasket between terminal box and transmitter is well aligned before
tightening the screw (Min. torque 0.5 Nm).
5.4 Remote system
The following chapters describe how to connect a remote system. If you want to connect a
compact system proceed with chapter Compact system (Page 32).
On sensor side:
1. Connecting Siemens sensor link cable (Page 38)
2. Finishing connection (Page 38)
On transmitter side:
1. Connecting battery (battery-powered versions and mains-powered versions with back-up
battery) (Page 39)
2. Connecting Siemens sensor link cable (Page 39)
3. Connecting power supply cable (main-powered systems only) (Page 40)
4. Connecting pulse output signal cable(s) (Page 41)
5. Finishing connection (Page 43)
Connecting
5.4 Remote system
SITRANS FUS380/FUE380
Operating Instructions, 05/2018, A5E00730100-AE 37
To Next Page
Loading...
