Functions
7
7.1 Unit selection
The device is delivered with totalizer and flow rate units in m and m
3
/h, respectively, as
standard. However, it is possible to manually configure the device to operate with other units.
Changing the units
Go via PDM menu [Device → Unit guide (offline)]. Select the new unit from the list and click on
[Apply Change of Units].
Figure 7-1 Unit selection
Click on the [Download to device] icon to apply the changes.
Note
The display is only able to show m
3
and m
3
/h
If the units are changed to units other than m
3
and m
3
/h, the display will not show any unit
indication after the measured value on the display. To show the new customer unit on the
display, a sticker can be used to show units. This sticker should be affixed to the transmitter
display.
SITRANS FUS380/FUE380
Operating Instructions, 05/2018, A5E00730100-AE 65
To Next Page
Loading...
