8.1
Checking the installation .........................................................................62
8.2
Preparing the control unit........................................................................62
8.3
Switching on the control unit for the first time .........................................63
8.4
System test..............................................................................................63
8.5
Completing commissioning .....................................................................63
9
Service....................................................................................................64
9.1
Testing the extinguishing system............................................................64
9.2
Checking the operating units ..................................................................64
9.3
Checking the extinguishing control unit ..................................................64
10
Detailed procedures..............................................................................65
10.1
Enabling access level 1...........................................................................65
10.2
Checking all optical and acoustic elements of the control unit ...............65
10.3
Enabling access level 2...........................................................................65
10.4
Test the alarm horn.................................................................................65
10.5
Testing the warning panel.......................................................................65
10.6
Calibrating control lines 4 and 5..............................................................66
10.7
Performing system test ...........................................................................67
11
Programming the user functions ........................................................68
11.1
Enabling access level 3...........................................................................68
11.2
Enabling access level 4...........................................................................68
11.3
Exiting program mode.............................................................................68
11.4
Resetting the user functions to default or application setting .................69
11.4.1
Overview of the default and application settings ....................................70
11.4.2
Description of the default settings...........................................................72
11.5
Query checksum .....................................................................................74
11.6
Programming steps.................................................................................75
11.6.1
Step 1, changing the activated time and function of control lines 4/5.....76
11.6.2
Step 2, change the flooding time (active period) of control lines 4/5 ......77
11.6.3
Step 3, change the function of the remote transmission.........................78
11.6.4
Step 4, change the function of the monitored inputs 1 and 2 .................79
11.6.5
Step 5, change the active mode of control lines 1 and 3........................80
11.6.6
Step 6, enable the "Alarm verification" function......................................81
11.6.7
Step 7, define the function of the yellow key (KEY8)..............................81
11.6.8
Step 8, change the function of the monitored input 3 .............................82
11.6.9
Step 9, change the parameters to the "Reset" function..........................84
11.6.10
Step 10, change the indication mode on the operator interface .............85
11.6.11
Step 11, change the function of the detector zones 1 to 3 .....................85
11.6.12
Step 12, change the code for access level 2 ..........................................86
11.6.13
Step 13, change the parameters of the operator interface .....................87
11.6.14
Step 14, change the fault delay upon "Mains failure" .............................88
11.6.15
Step 15, change the function of the control inputs 2 to 4........................88
11.6.16
Step 16, change the function of the driver outputs 2, 8 and 1 ................89
12
Log sheet of programmed user functions..........................................90
13
Ordering information ............................................................................91
To Next Page
Loading...
