Siemens XC1003-A - 11.6.13 Step 13, Change the Parameters of the Operator Interface

Programming the user functions
87
Building Technologies A6V10099837_a_en
Fire Safety & Security Products 12.2007
11.6.13 Step 13, change the parameters of the operator interface
Change the processing of "Fire alarm condition"
Zone 1
Zone 2 Zone 3 Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
1 (default)
“Fire alarm” also in state “Manual only”:
– LED6 = lit in steady mode, LED7 = flashing fast
– Active: Horns, monitored control lines and outputs programmed as
activated on fire alarm condition
–
KEY13
▼
2
No “Fire alarm” in state “Manual only”:
– LED6 = lit in steady mode, LED7 = OFF
– Not active: Horns, monitored control lines and outputs programmed
as activated on fire alarm condition
Change the function of the key "Silence buzzer" (KEY15)
Zone 1
Zone 2 Zone 3 Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
3 (default)
Only for "Silence buzzer" in state "Fire alarm" –
KEY13
▼
4 For "Silence buzzer" and "Silence Re-sound horn" in state "Fire alarm"
Enable the function "Reminder beep"
Zone 1
Zone 2
Zone 3 Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
5 (default)
No reminder beep –
KEY14
▼
6 Buzzer sounds every 4 min for 1 sec in case of "Fault" or "Disabled"
Enable the function "Fault to be reset"
Zone 1
Zone 2
Zone 3 Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
7 (default)
Faults must not be reset –
KEY14
▼
8 All faults must be reset
Enable the function "RT-alarm + RT-fault suppressed on access level 2"
Zone 1 Zone 2
Zone 3
Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
9 (default)
No blocking –
KEY15
▼
10 "RT-alarm" and "RT-fault" disabled on state "Access level 2 enabled"
Enable the function "Reset via control input 1 suppressed upon RT-alarm"
Zone 1 Zone 2
Zone 3
Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
11 (default)
Not blocked –
KEY15
▼
12 Blocked on state "RT-alarm"
Suppress the "Battery fault"
Zone 1 Zone 2 Zone 3
Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
13 (default)
Battery fault not suppressed –
KEY16
▼
14 Battery fault suppressed
Change the active mode of the buzzer in state "Emergency hold/abort"
Zone 1 Zone 2 Zone 3
Zone 4
Select Option Function
Red
Yel.
Red
Yel.
Red
Yel.
Red
Yel.
15 (default)
1 sec beep with begin and end of state "Emergency hold/abort" –
KEY16
▼
16 Active until key "Silence buzzer" is pressed