Siemens XC1003-A - Page 51

Planning
51
Building Technologies A6V10099837_a_en
Fire Safety & Security Products 12.2007
IN2 IN1
CL6-2 CL6-1
Fault
CL5-2 CL5-1
3,01 kΩ
Released or Activated and Released
IN3
CL7-2 CL7-1
Fire alarm or Fire alarm and Activated
1,15 kΩ
InputsOutputs
XCM1001-1
CL16-1
D
Auto. & Man. blocked (**)
FDCIO222
Detector bus FDnet
(*) Only if I/O module is installed outside the control unit
(**) Under condition that I/O module is installed inside the control unit
CL8-1
Auto. & Man. blocked (**) Manual only (**)
CL8-2 CL9-2 CL9-1
3,01 kΩ
IN4
3,01 kΩ 3,01 kΩ
1,15 kΩ 1,15 kΩ
AC
1
+
B
2
CL6-2 CL6-1
3
CL7-1
Reset (**) Manual only (**)
(*) (*) (*)
L R
PU6
L R
PU5
L R
PU4
L R
PU3
L R
PU2
5 4 3 2 1
XCM1001-2
Fig. 36 Automatic triggering from the extinguishing control unit
Details on jumper PU2-6 setting, see chapter 5.3.2.
For possible connections to a fire detection system please see the relevant document.
Country-specific and local standards describe the approved connections from the danger
management system to an extinguishing system!