SimCom SIM7600 Series User Manual

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
113
Write command controls whether or not intermediate result code “+CR: <serv>” is returned from
the TA to the TE. If enabled, the intermediate result code is transmitted at the point during connect
negotiation at which the TA has determined which speed and quality of service will be used, before
any error control or data c
ompression reports are transmitted, and before the intermediate result
code CONNECT is transmitted.
SIM PIN References
YES
3GPP TS 27.007
Syntax
Test Command Responses
AT+CR=? +CR: (list of supported <mode>s)
OK
Read Command Responses
AT+ CR? +CR: <mode>
OK
Write Command
Responses
AT+CR=<mode> OK
Execution Command Responses
AT+CR Set default value:
OK
Defined values
<mode>
0 – disables reporting
1 – enables reporting
<serv>
ASYNC asynchronous transparent
SYNC synchronous transparent
REL ASYNC asynchronous non-transparent
REL sync synchronous non-transparent
GPRS [<L2P>] GPRS
The optional <L2P> proposes a layer 2 protocol to use between the MT and the TE.
Examples
AT+CR?
+CR:0
OK
AT+CR=1
OK
SIMCOM CONFIDENTIAL FILE

SimCom SIM7600 Series Specifications

General

Brand	SimCom
Model	SIM7600 Series
Category	Control Unit
Language	English