Simulator | 17
3 Using the simulator
Simulator mode
The simulation feature main data sources, so you can see how the unit works without
being connected to echosounder, radar, GPS etc.
You can use the simulator to help you become familiar with your unit before using it out
on the water.
When the simulator is toggled on this is indicated in the lower part of
the display.
Demonstration mode
In this mode the unit automatically runs through the main features of
the product; it changes pages automatically, adjusts settings, opens
menus etc.
If you press a key when demo mode is running, the demonstration will
pause. After a time-out period, demo mode will resume again.
Advanced simulator settings
The advanced simulator settings allows you to define how to run the
simulator. When the settings are saved these will be used as default
when starting the simulator mode.
Selects data to be used.
A set of source files is included in your system, and you
can import files by using a USB stick or a memory card.
Refer to The utilities pages section.
You can also use your own recorded echosounder files in
the simulator.
For how to record echosounder files, refer to the Using
the echosounder section.
GPS source
Selects where the GPS data is generated from.
Speed, Course and Route
Used for manually enter values when GPS source is set to
Simulated course or Simulated route. Otherwise, GPS
data including speed and course comes from the selected echosounder or radar files.
Set start position
Moves the vessel to current cursor position.
MENU WIN
x2
To Next Page
Loading...
Need help?
General
