64 57 316 D3543
16 D3543.076.01.04.02 06.2015
5Important information Sirona Dental Systems GmbH
5.1Storage location for system- and user-specific data Service Manual INTEGO / INTEGO pro
5
Important information
5.1
Storage location for system- and user-specific
data
The treatment center features a central unit memory, which is
permanently connected to the center. Consequently, data does not have
to be backed up and written back if the board is replaced.
Composition of DTC data
The DTC data is made up of the operating data, the service log, the
device configurations, the DTC settings, and the dentist data.
DTC data General definition Example
Operating data Recorded operational periods, operating states
of service/maintenance-related functions, and
registered maintenance and service operations
Sanitation, purge and auto-purge
logs; lifting and backrest motor duty
cycles; amalgam separator filling
level; Sprayvit vent
Service log Service information from the "info", "warning",
"error" categories and user information (always
provided in conjunction with the time when it was
recorded)
Device configurations It is always the most recently detected
configuration that is saved. This consists of all
the boards that can be detected by the SW
(together with serial numbers and detectable
options/versions, where applicable)
Module (DWE, DAB, etc.), serial
numbers (treatment center, boards)
DTC settings All the settings for functions that are
independent of the dentist
MSBV opening time, IP address, etc.
Dentist data All the settings for functions that are dependent
on the dentist
Flushing time, tumbler filling time,
instrument setting, chair programs,
LED lamp, etc.
IMPORTANT
The DUMC displays service information only.
To Next Page
Loading...
