Sirona Intego - Maintenance and repair

64 57 316 D3543
D3543.076.01.04.02 06.2015
17
Sirona Dental Systems GmbH 5Important information
Service Manual INTEGO / INTEGO pro 5.2Installing the treatment center software
båÖäáëÜ
5.2
Installing the treatment center software
Users can install the firmware via the PC program (DUMC) in two different
ways. They can either install it directly using the optionally available
Ethernet interface or they can copy it onto an SD card and then transfer
it to the treatment center.
Installing the software via a LAN
✔ The treatment center is switched off.
✔ The connection box cover on the patient chair has been removed
(see Removing the connection box cover [ → 97]).
1. Use an Ethernet cable to connect the service notebook to the RJ45
socket on the DSL board.
2. Switch the treatment center on.
For details of how to use the DUMC to install the latest firmware on the
treatment center directly via a LAN, please refer to the "Dental Unit
Management Console Service Manual" (DUMC) with order number
6194497.
IMPORTANT
During the software installation via LAN, no SD card with activated
download process may be inserted at system start.