Transmission
6-4
31211015 6036, 6042, 8042, 10042, 10054
9. Place a suitable receptacle under transmission drain
plug (1). Remove transmission drain plug, and allow
transmission oil to drain into receptacle.
10. Transfer the used transmission oil into a suitable,
covered container, and label the container as “Used Oil”.
Dispose of used oil at an approved recycling facility.
Clean and reinstall the transmission drain plug.
11. Remove the engine-to- transmission and transmission-
to-axle drive shafts. Refer to Section 5.5.2, “Drive Shaft
Removal”.
12. Remove the hydraulic pump. Refer to Section 8.7.1,
“Pump Replacement”
.
13. Label and disconnect the transmission temperature
switch connector (2) and shift solenoid wiring harness
connectors (3).
14. Remove the capscrew securing the black wire (4) to the
transmission housing, and disconnect the wire. DO NOT
reinstall the capscrew at this time.
15. Remove the capscrew securing the clamp (5) and wiring
harness to the transmission housing and move the
wiring harness safely out of the way. DO NOT reinstall
the capscrew at this time.
16. Remove the capscrew (6) securing the lifting ring (7) to
the transmission housing. Once the lifting ring has been
removed, reinstall the capscrew into the hole.
17. Move the lifting ring to the holes (8) used to secure the
black wire and clamp. Secure the lifting ring using the
capscrews and tighten securely.
18. Label, disconnect and cap the transmission oil cooler
inlet and outlet hoses on the transmission.
19. Connect a lifting strap or chain to the lifting eye at the
top of the transmission and to a suitable hoist or
overhead crane. Operate the hoist or crane to remove
slack from the chain, but DO NOT raise the transmission
at this time.
20. Place blocks under the transmission to help support it
during removal.
To Next Page
