Stabil-TRAK™ System and Boom Interlock System
10-13
6036, 6042, 8042, 10042, 10054 31211015
Stabil-TRAK System Test Procedures
Step 1
a. Place the machine on a level surface with 0° level.
b. Have the boom fully retracted and horizontal.
c. Place an 8in (203 mm) wood or cement block in front of the front left tire.
d. Enter the machine.
e. Fasten the seat belt.
f. Turn the key to the RUN position.
g. Check to be sure the Stabil-TRAK light is OFF.
Step 2
a. Start the engine.
b. Turn the parking brake switch OFF.
c. Move the transmission to (1) FIRST gear.
d. Move the transmission to the (F) FORWARD position.
e. Drive the machine up on the block and stop by applying service brake with left foot.
f. Use the frame level control to level the machine back to 0°.
Step 3
a. Place the transmission in(N) NEUTRAL.
b. Raise the boom to approximately 60°. The Stabil-TRAK light should come ON when the boom angle is at
about 40° and remain ON.
Step 4
a. Continue using your left foot to depress the service brake pedal.
b. With transmission in (2) SECOND gear, move travel select lever to (R) REVERSE position.
c. Ease your left foot partially off the service brake pedal, make sure that the Stabil-TRAK light remains ON.
d. With your right foot, increase the engine rpm slightly, as necessary, just enough to back the machine off
the block. While backing off the block, the front left tire should remain off the ground.
IMPORTANT: Perform Steps 5 thru 9 with the engine rpm at idle.
Step 5
a. Keep the service brake pedal depressed.
b. Place the transmission in (N) NEUTRAL.
c. Take your foot off the service brake pedal. The Stabil-TRAK light should remain ON and the front left tire
should remain off the ground.
Step 6
a. With the transmission in (N) NEUTRAL, engage the parking brake switch.
b. Move the transmission to the (F) FORWARD position. The Stabil-TRAK light should remain ON and the front
left tire should remain off the ground.
FREE PIVOT MODE
LOCKED MODE
Service Brake TestNeutral TestPark Brake Test
To Next Page
