Smart Electronic CX20 - Set Time

Basic Operation
32 smart CX20
5.8 Set Time
Reasonable operation of the smart CX20 and above all the use of the PVR
(video recorder) require setting of system time. By default, the receiver is
set to GMT
11
Usage, i.e. date and time are taken from the received signal.
Time zone is set to GMT + 1 hour (+ 1:00) by default. Required changes
can be made in the sub-menu Time:
1. Select the menu System Setup (see above).
2. Select the sub-menu Time
and confirm by pressing OK.
3. Select the item GMT Usage and switch on or off GMT Usage by using
the keys / or / .
On = automatic time setting via satellite signal is activated.
Off = automatic time setting via satellite signal is deactivated.

smart recommends to keep the presetting
(GMT Usage
On
)
.
4. Select the item GMT and select your time zone by using the keys /
or / ; for example, the time zone of Germany, Austria and
Switzerland is GMT +1:00.
5. Select the item Summer Time
and switch Summer Time Off or On by
using the keys / or / .

 Please verify the presetting and correct them, if re-
quired. Please also consider corresponding change of
those settings.
6. If automatic time setting (GMT Usage) is switched off, then date and
time should be manually entered:
For this, select the item Date, select the position to be changed by us-
ing the keys / or / , and enter the current date by using
the numeric keys. Then, select the item Time, select the position to be
changed by using the keys / or / , and enter the current
time by using the numeric keys.
11
GMT = Greenwich Mean Time