Smart Electronic CX20 - Channel Selection via Selection Window

Basic Operation
34 smart CX20

 Press INFO to call this window at any time.
 Set display time at OSD Timeout (see section "OSD
Setting", page 64).

Press EXIT two times to close the information window.
5.9.2 Channel Selection via Selection Window
1. Press OK to display a selection
window with all available chan-
nels (3).
2. Select the channel list with the
desired channel by using the
keys / or / (1)
or
Press FAV to select from your
favorite lists (see p. 46).
3. Select the channel to be displayed (2) by using the keys / PR+ and
/ PR- for single steps or
P+ and P- for steps of ten, and confirm
your selection by pressing
OK.
The channel will be correspondingly switched.
4. Press OK or EXIT to close the selection window.
Channel selection window
:
No.
Description
1
Display of current channel list
2
Marked channel
3
Channels included in the current channel list
4
Frequency of current channel (example: 33800 is 338.00 MHz)
5
Symbol rate of current channel (in megasymbols/second)