Smart Electronic CX20 - Simultaneous Playback of Picture and Sound; ANT in; out Loop through (Loop Standby); Information Regarding the CI Module

Extended Settings and Functions
smart CX20 65
7.3.4.3 Simultaneous Playback of Picture and Sound
Asynchrony between the image and the sound signals might for example
occur in your home cinema system due to the use of long cables. Your
smart CX20 offers the possibility to balance this by slightly shifting the
audio against the video signal.
1. Select AV Sync Type
to switch On and Off the possibility of shifting
audio and video signals against each other using the buttons /
and / (factory default is AV Sync Type
Off ).
2. Select AV Sync Value
and press OK to set a value of shift between -
500ms
and +500ms using the buttons / and / (factory
default is AV Sync Value
0 ms ).
7.3.4.4 ANT IN / OUT Loop Through (Loop Standby)
Basically, after turning off the receiver it switches to power saving mode
("Deep Standby", red LED lights up). At the ANT OUT terminal there is no
or only a highly attenuated signal. If you want to use ANT OUT anyway,
you can set that in the submenu Other
of the System Setup menu:
 Select Loop Standby to switch on and off the possibility of looping
through the cable signal, using the keys / and / (factory
default is Loop Standby
off ).
CAUTION!
If you select Loop Standby On
, the receiver goes into
standby mode after switching off, but not into the pow-
er saving mode. The display shows the current time.
7.3.4.5 Information Regarding the CI Module
 Select CAM Message Mode, to select - using the keys / and
/ - whether information regarding the CI module should be dis-
played (
On ) or not ( Off ). Factory default is CAM Message Mode Off .