C
ONFIGURING
THE
S
WITCH
3-110
• Capabilities – Specifies the capabilities to be advertised for a port
during auto-negotiation. (To access this item on the web, see
“Configuring Interface Connections” on page 3-48.) The following
capabilities are supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
- 1000full - Supports 1000 Mbps full-duplex operation
- Sym - Transmits and receives pause frames for flow control
- FC - Supports flow control
•Broadcast storm – Shows if broadcast storm control is enabled or
disabled.
• Broadcast storm limit – Shows the broadcast storm threshold.
(240 - 1488100 packets per second)
• Flow control – Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port Security – Shows if port security is enabled or disabled.
• Max MAC count – Shows the maximum number of MAC address
that can be learned by a port. (0 - 1024 addresses)
• Port security action – Shows the response to take when a security
violation is detected. (shutdown, trap, trap-and-shutdown)
Current status:
• Link Status – Indicates if the link is up or down.
• Port Operation Status – Provides detailed information on port state.
(Displayed only when the link is up.)
• Operation speed-duplex – Shows the current speed and duplex
mode.
• Flow control type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
To Next Page
Loading...
Need help?
General
