SNMP C
OMMANDS
4-137
Example
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP
views. Use the no form to remove an SNMP group.
Syntax
snmp-server group groupname {v1 | v2c | v3 {auth | noauth |
priv}} [read readview] [write writeview] [notify notifyview]
no snmp-server group groupname
• groupname - Name of an SNMP group. (Range: 1-32 characters)
• v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
- auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See “Simple Network Management Protocol” on
page 3-44 for further information about these authentication and
encryption options.
Console#show snmp view
View Name: mib-2
Subtree OID: 1.2.2.3.6.2.1
View Type: included
Storage Type: nonvolatile
Row Status: active
View Name: defaultview
Subtree OID: 1
View Type: included
Storage Type: nonvolatile
Row Status: active
Console#
Table 4-39 show snmp view - display description
Field Description
View Name Name of an SNMP view.
Subtree OID A branch in the MIB tree.
View Type Indicates if the view is included or excluded.
Storage Type The storage type for this entry.
Row Status The row status of this entry.
To Next Page
Loading...
Need help?
General
