SMC Networks TigerSwitch SMC6128L2

I NTERFACE C OMMANDS
4-145
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following example adds a description to port 24.
speed-duplex
This command configures the speed and duplex mode of a given interface
when autonegotiation is disabled. Use the no form to restore the default.
Syntax
speed-duplex {1000full | 100full | 100half | 10full | 10half}
no speed-duplex
• 1000full - Forces 1000 Mbps full-duplex operation
• 100full - Forces 100 Mbps full-duplex operation
• 100half - Forces 100 Mbps half-duplex operation
• 10full - Forces 10 Mbps full-duplex operation
• 10half - Forces 10 Mbps half-duplex operation
Default Setting
• Auto-negotiation is enabled by default.
• When auto-negotiation is disabled, the default speed-duplex setting is
1000full for Gigabit Ethernet ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To force operation to the speed and duplex mode specified in a
speed-duplex command, use the no negotiation command to
disable auto-negotiation on the selected interface.
Console(config)#interface ethernet 1/24
Console(config-if)#description RD-SW#3
Console(config-if)#