A
DDRESS
T
ABLE
C
OMMANDS
4-179
Example
mac-address-table aging-time
This command sets the aging time for entries in the address table. Use the
no form to restore the default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 10-1000000 seconds;
0 to disable aging)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The aging time is used to age out dynamically learned forwarding
information.
Example
Console#show mac-address-table
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/ 1 00-00-00-00-00-17 1 Learned
Eth 1/ 1 00-E0-29-94-34-DE 1 Delete-on-reset
Console#
Console(config)#mac-address-table aging-time 100
Console(config)#
To Next Page
Loading...
Need help?
General
