L
INE
C
OMMANDS
4-23
Command Usage
Communication protocols provided by devices such as terminals and
modems often require a specific parity bit setting.
Example
To specify no parity, enter this command:
speed
This command sets the terminal line’s baud rate. This command sets both
the transmit (to terminal) and receive (from terminal) speeds. Use the no
form to restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps, or auto)
Default Setting
auto
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the
serial port. Some baud rates available on devices connected to the port
might not be supported. The system indicates if the speed you selected
is not supported. If you select the “auto” option, the switch will
automatically detect the baud rate configured on the attached terminal,
and adjust the speed accordingly.
Console(config-line)#parity none
Console(config-line)#
To Next Page
Loading...
Need help?
General
