C
OMMAND
L
INE
I
NTERFACE
4-280
• Switch clusters are limited to a single IP subnet (Layer 2 domain).
• A switch can only be a Member of one cluster.
• Configured switch clusters are maintained across power resets and
network changes.
Example
cluster commander
This command enables the switch as a cluster Commander. Use the no
form to disable the switch as cluster Commander.
Syntax
[no] cluster commander
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• Once a switch has been configured to be a cluster Commander, it
automatically discovers other cluster-enabled switches in the network.
These “Candidate” switches only become cluster Members when
manually selected by the administrator through the management
station.
• Cluster Member switches can be managed through only using a Telnet
connection to the Commander. From the Commander CLI prompt,
use the rcommand id command to connect to the Member switch.
Example
Console(config)#cluster
Console(config)#
Console(config)#cluster commander
Console(config)#
To Next Page
Loading...
Need help?
General
