DHCP S
NOOPING
C
OMMANDS
4-273
Command Usage
• When DHCP snooping enabled globally using the ip dhcp snooping
command (page 4-270), and enabled on a VLAN with this command,
DHCP packet filtering will be performed on any untrusted ports
within the VLAN as specified by the ip dhcp snooping trust
command (page 4-273).
• When the DHCP snooping is globally disabled, DHCP snooping can
still be configured for specific VLANs, but the changes will not take
effect until DHCP snooping is globally re-enabled.
• When DHCP snooping is globally enabled, configuration changes for
specific VLANs have the following effects:
- If DHCP snooping is disabled on a VLAN, all dynamic bindings
learned for this VLAN are removed from the binding table.
Example
This example enables DHCP snooping for VLAN 1.
Related Command
ip dhcp snooping (4 -270)
ip dhcp snooping trust (4 -273)
ip dhcp snooping trust
This command configures the specified interface as trusted. Use the no
form to restore the default setting.
Syntax
[no] ip dhcp snooping trust
Default Setting
All interfaces are untrusted
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#ip dhcp snooping vlan 1
Console(config)#
To Next Page
Loading...
