SMC Networks TigerSwitch SMC6128L2

C OMMAND L INE I NTERFACE
4-200
switchport mode
This command configures the VLAN membership mode for a port. Use
the no form to restore the default.
Syntax
switchport mode {hybrid | access}
no switchport mode
• hybrid - Specifies a hybrid VLAN interface. The port may
transmit tagged or untagged frames.
• access - Specifies an access VLAN inferface. The port transmits
and receives untagged frames only.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following shows how to set the configuration mode to port 1, and
then set the switchport mode to hybrid:
Related Commands
switchport acceptable-frame-types (4 -200)
switchport acceptable-frame-types
This command configures the acceptable frame types for a port. Use the
no form to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
• all - The port accepts all frames, tagged or untagged.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#