SMC Networks TigerSwitch SMC6128L2

C OMMAND L INE I NTERFACE
4-246
ip igmp filter (Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the
switch. Use the no form to remove a profile from an interface.
Syntax
[no] ip igmp filter profile-number
• profile-number - An IGMP filter profile number. (Range:
1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
• The IGMP filtering profile must first be created with the ip igmp
profile command before being able to assign it to an interface.
• Only one profile can be assigned to an interface.
• A profile can be assigned to a trunk interface. When ports are
configured as trunk members, the trunk uses the filtering profile
assigned to the first port member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#