F
LASH
/F
ILE
C
OMMANDS
4-89
Command Usage
• If you enter the command dir without any parameters, the system
displays all files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Example
The following example shows how to display all file information.
whichboot
This command displays which files were booted when the system powered
up.
Syntax
whichboot [unit]
unit - Stack unit. (Range: 1-8)
Default Setting
None
Table 4-26 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config
file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
Console#dir
file name file type startup size (byte)
-------------------------------- -------------- ------- -----------
Unit1:
diag_0060 Boot-Rom image Y 111360
run_01642 Operation Code N 1074304
run_0200 Operation Code Y 1083008
Factory_Default_Config.cfg Config File N 2574
startup Config File Y 2710
-------------------------------------------------------------------
Total free space: 0
Console#
To Next Page
Loading...
