C
OMMAND
L
INE
I
NTERFACE
4-224
Example
The following example shows how to change the CoS assignments to a
one-to-one mapping.
Related Commands
show queue cos-map (4 -225)
show queue mode
This command shows the current queue mode.
Default Setting
None
Command Mode
Privileged Exec
Example
show queue bandwidth
This command displays the weighted round-robin (WRR) bandwidth
allocation for the eight priority queues.
Default Setting
None
Console(config)#interface ethernet 1/1
Console(config-if)#queue cos-map 0 0
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#exit
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
Traffic Class : 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 3 4 5 6 7
Console#
Console#sh queue mode
Wrr status: Enabled
Console#
To Next Page
Loading...
Need help?
General
