C
OMMAND
L
INE
I
NTERFACE
4-250
show ip igmp throttle interface
This command displays the interface settings for IGMP throttling.
Syntax
show ip igmp throttle interface [interface]
•interface
• ethernet unit/port
- unit - This is unit 1.
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-4)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Using this command without specifying an interface displays all
interfaces.
Example
Multicast VLAN Registration Commands
This section describes commands used to configure Multicast VLAN
Registration (MVR). A single network-wide VLAN can be used to transmit
multicast traffic (such as television channels) across a service provider’s
network. Any multicast traffic entering an MVR VLAN is sent to all
subscribers. This can significantly reduce to processing overhead required
to dynamically monitor and establish the distribution tree for a normal
Console#show ip igmp throttle interface ethernet 1/1
Information of Eth 1/1
status : TRUE
action : deny
max multicast groups : 32
current multicast groups : 0
Console#
To Next Page
Loading...
Need help?
General
