F
LASH
/F
ILE
C
OMMANDS
4-87
This example shows how to copy a public-key used by SSH from an TFTP
server. Note that public key authentication via SSH is only supported for
users configured locally on the switch.
delete
This command deletes a file or image.
Syntax
delete [unit:] filename
filename - Name of the configuration file or image name.
unit - Stack unit. (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If the file type is used for system startup, then this file cannot be
deleted.
• “Factory_Default_Config.cfg” cannot be deleted.
• A colon (:) is required after the specified unit number.
Console#copy tftp public-key
TFTP server IP address: 192.168.1.19
Choose public key type:
1. RSA: 2. DSA: <1-2>: 1
Source file name: steve.pub
Username: steve
TFTP Download
Success.
Write to FLASH Programming.
Success.
Console#
To Next Page
Loading...
Need help?
General
