C
ONFIGURING
THE
S
WITCH
3-174
• Acceptable Frame Type – Sets the interface to accept all frame types,
including tagged or untagged frames, or only tagged frames. When set
to receive all frame types, any received frames that are untagged are
assigned to the default VLAN. (Option: All, Tagged; Default: All)
• Ingress Filtering – Determines how to process frames tagged for
VLANs for which the ingress port is not a member. Ingress Filtering
is always enabled. (Default: Enabled)
- Ingress filtering only affects tagged frames.
- If a port receives frames tagged for VLANs for which it is not a
member, these frames will be discarded.
-
Ingress filtering does not affect VLAN independent BPDU frames,
such as GVRP
or STP. However, they do affect VLAN dependent
BPDU frames, such as GMRP.
• Mode – Indicates VLAN membership mode for an interface.
(Default: Hybrid)
- 1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port transmits
tagged frames that identify the source VLAN. However, note that
frames belonging to the port’s default VLAN (i.e., associated with
the PVID) are also transmitted as tagged frames.
- Hybrid – Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
• Trunk Member – Indicates if a port is a member of a trunk. To add a
trunk to the selected VLAN, use the last table on the VLAN Static
Table page.
To Next Page
Loading...
Need help?
General
