Q
UALITY
OF
S
ERVICE
3-201
Command Attributes
Policy Map
• Modify Name and Description – Configures the name and a brief
description of a policy map. (Range: 1-16 characters for the name; 1-64
characters for the description)
• Edit Classes – Opens the “Policy Rule Settings” page for the selected
class entry. Modify the criteria used to service ingress traffic on this
page.
• Add Policy – Opens the “Policy Configuration” page. Enter a policy
name and description on this page, and click Add to open the “Policy
Rule Settings” page. Enter the criteria used to service ingress traffic on
this page.
• Remove Policy – Deletes a specified policy.
Policy Configuration
• Policy Name – Name of the policy map. (Range: 1-16 characters)
• Description – A brief description of a policy map.
(Range: 1-64 characters)
• Add – Adds the specified policy.
• Back – Returns to previous page without making any changes.
Policy Rule Settings
- Class Settings -
• Class Name – Name of class map.
• Action – Shows the service provided to ingress traffic by setting a CoS,
DSCP, or IP Precedence value in a matching packet (as specified in
Match Class Settings on 3-197).
• Meter – The maximum throughput and burst rate.
- Rate (kbps) – Rate in kilobits per second.
- Burst (byte) – Burst in bytes.
• Exceed Action – Specifies whether the traffic that exceeds the
specified rate will be dropped or the DSCP service level will be
reduced.
To Next Page
Loading...
Need help?
General
