C
OMMAND
L
INE
I
NTERFACE
4-12
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
NE (Normal Exec)
Link Aggregation Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control
Protocol for port trunks
4-162
Address Table Configures the address table for filtering specified
addresses, displays current entries, clears the table,
or sets the aging time
4-175
Spanning Tree Configures Spanning Tree settings for the switch 4-180
VLANs Configures VLAN settings, and defines port
membership for VLAN groups; also enables or
configures private VLANs
4-196
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for the
bridge extension MIB
4-214
Priority Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight
for each priority queue, also sets priority for TCP/
UDP traffic types, and DSCP
4-219
Multicast Filtering Configures IGMP multicast filtering, query
parameters, and specifies ports attached to a
multicast router
4-229
IP Interface Configures IP address for the switch 4-258
IP Source Guard Configures IP source guard security. 4-264
DHCP Snooping Configures DHCP snooping 4-269
Switch Cluster Configures switch clustering 4-278
Table 4-4 Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
Need help?
General
