C
OMMAND
L
INE
I
NTERFACE
4-78
• Use this command in conjunction with the show startup-config
command to compare the information in running memory to the
information stored in non-volatile memory.
• This command displays settings for key command modes. Each mode
group is separated by “!” symbols, and includes the configuration
mode command, and corresponding commands. This command
displays the following information:
- SNMP community strings
- Users (names, access levels, and encrypted passwords)
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- IP address configured for the switch
- Spanning tree settings
- Any configured settings for the console port and Telnet
To Next Page
Loading...
