C
OMMAND
L
INE
I
NTERFACE
4-124
v1, v2c or v3) and security level (i.e., authentication and privacy), and then
assign SNMP users to these groups, along with their specific
authentication and privacy passwords.
Table 4-37 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMPv3 server GC 4-125
show snmp Displays the status of SNMP
communications
NE,
PE
4-125
snmp-server
community
Sets up the community access string to
permit access to SNMP commands
GC 4-127
snmp-server contact Sets the system contact string GC 4-127
snmp-server
location
Sets the system location string GC 4-128
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 4-129
snmp-server enable
traps
Enables the device to send SNMP traps (i.e.,
SNMP notifications)
GC 4-132
snmp-server
engine-id
Sets the SNMPv3 engine ID GC 4-133
show snmp
engine-id
Shows the SNMPv3 engine ID PE 4-134
snmp-server view Adds an SNMPv3 view GC 4-135
show snmp view Shows the SNMPv3 views PE 4-136
snmp-server group Adds an SNMPv3 group, mapping users to
views
GC 4-137
show snmp group Shows the SNMPv3 groups PE 4-138
snmp-server user Adds a user to an SNMPv3 group GC 4-140
show snmp user Shows the SNMPv3 users PE 4-142