SNMP C
OMMANDS
4-131
2. Allow the switch to send SNMP traps; i.e., notifications
(page 4-132).
3. Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
4. Create a view with the required notification messages (page 4-135).
5. Create a group that includes the required notify view (page 4-137).
To send an inform to a SNMPv3 host, complete these steps:
1. Enable the SNMP agent (page 4-125).
2. Allow the switch to send SNMP traps; i.e., notifications
(page 4-132).
3. Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
4. Create a view with the required notification messages (page 4-135).
5. Create a group that includes the required notify view (page 4-137).
6. Specify a remote engine ID where the user resides (page 4-133).
7. Then configure a remote user (page 4-140).
• The switch can send SNMP version 1, 2c, or 3 notifications to a host
IP address, depending on the SNMP version that the management
station supports. If the snmp-server host command does not specify
the SNMP version, the default is to send SNMP version 1
notifications.
• If you specify an SNMP Version 3 host, then the community string is
interpreted as an SNMP user name. If you use the V3 “auth” or “priv”
options, the user name must first be defined with the snmp-server
user command. Otherwise, the authentication password and/or
privacy password will not exist, and the switch will not authorize
SNMP access for the host. However, if you specify a V3 host with the
“noauth” option, an SNMP user account will be generated, and the
switch will authorize SNMP access for the host.
To Next Page
Loading...
Need help?
General
