Snom D717 - Auto Dial Target

103
D717 User Manual Customizing the Phone Settings
4. Select Timer and press .
5. Enter a time span in seconds from 1 to 10 and press . As of FW 10.1.26, the valid time span is 1
to 2147483647 (68.1 years).
6. Press to save and to return to the Auto dial menu.
7. Press briefly to return to the Call Features menu, press for two seconds to return to the idle
screen.
Setting on the web interface
1. Open the Advanced Settings page and select the Behavior tab.
2. In the Phone behavior section enter a a time span in seconds from 1 to 10 in the text field of the
Auto dial timeout setting. As of FW 10.1.26, the valid time span is 1 to 2147483647 (68.1 years).
3. Click on Apply and Save.
Auto dial target
In the default setting, this function is switched o. When it is enabled (see "Auto dial" on page 102),
the phone will dial the number on the display when the time span in seconds specified in Timer (see
phone) or Auto dial timeout (web interface), respectively, has elapsed after the receiver was taken
o-hook. The setting is accessible in admin mode only.
Setting on the phone
1. Press .
2. Select Call Features > Outgoing calls > Auto dial and press . The Auto Dial screen appears.
3. Select Target and press .
4. Enter the target (a phone number or IP address) and press .
5. Press to save and to return to the Auto dial menu.
6. Press briefly to return to the Call Features menu, press for two seconds to return to the idle
screen.
Setting on the web interface
1. Open the Advanced Settings page and select the Behavior tab.
2. In the Phone behavior section enter the target (a phone number or IP address) in the text field of
the Auto dial target setting.
3. Click on Apply and Save.