22
D717 User Manual Getting to Know Your Phone
Hold key. See "Hold" on page 58 for further information.
Turn "do not disturb" (DND) mode on and o for all identities registered on the phone
(Fig. 1). If you want to turn on DND for one or more, but not all of the identities (Fig. 2),
use the Configuration identity settings on the phone's web user interface. In DND mode
incoming calls do not ring; callers hear the busy signal.
Exception:
Phone numbers on your directory's VIP list (see "Contact Types" on page 42)
.
When DND is on, you'll see the DND symbol on the display.
Fig.1 - DND active Fig. 2 - DND active for one of the configured identities
Audio control keys
Press the right or left edge of the key to adjust the volume
• of the ringer when the phone is idle or ringing
• of the loudspeaker in handset, casing, or headset, respectively, when in call
Muting and unmuting the microphone
• Toggling between handsfree and handset mode
• Dialing numbers on speakerphone
• Accepting calls on speakersphone
Toggling between headset and handset modes.
Note: Handset mode overrides headset mode. When the handset is picked up, the
headset symbol in the status line will be replaced by the handset symbol, indicating
that you can now use only the handset for the call. To return audio to the headset,
press again. The headset symbol will reappear in the status line. You can then
place the handset in the cradle without ending the call.
SmartLabel keys (freely programmable function keys with LEDs)
These three freely programmable function keys on the right side of the display control the
SmartLabels (see "SmartLabels" on page 27). They can be programmed and labeled on the phone
and on the Function Keys page of the phone's web interface. For information on how to map functions
onto these keys, see "Configuring the function keys" on page 70. The factory default setting is line.
To Next Page
Loading...
