SNR S2940-8G-v2 Switch Configuration Guide
CFM-OAM Configuration
• It will only develop the MIP as the port status as UP; one port bases on one vlan to develop
only one MIP; lower MIP point will have higher priority to develop.
• A DOWN attribute MA is only need to configure on the port, if there is configured the MEP
point in the port, then it cannot develop the MIP, even if there is configured the port-channel,
it will cause the MEP ineffective. MIP cannot develop in the MA.
If it cannot solve the problem of CFM OAM after checking, then please using the debug ethernet
cfm etc command, and copy the DEBUG information (3 minutes), and then sending to the technical
center of our company.
122
To Next Page
Loading...
General