SNR S2940-8G-v2 User Manual

SNR S2940-8G-v2 Switch Configuration Guide
GVRP Configuration
Switch(config)#interface ethernet 1/11
Switch(Config-If-Ethernet1/11)#switchport mode trunk
Switch(Config-If-Ethernet1/11)#gvrp
Switch(Config-If-Ethernet1/11)#exit
Switch C:
Switch(config)#gvrp
Switch(config)#vlan 100
Switch(Config-Vlan100)#switchport interface ethernet 1/2-6
Switch(Config-Vlan100)#exit
Switch(config)#interface ethernet 1/11
Switch(Config-If-Ethernet1/11)#switchport mode trunk
Switch(Config-If-Ethernet1/11)#gvrp
Switch(Config-If-Ethernet1/11)#exit
22.4 GVRP Troubleshooting
The GARP counter setting for Trunk ports in both ends of Trunk link must be the same, otherwise
GVRP will not work normally. It is recommended to avoid enabling GVRP and RSTP at the same
time in switch. If GVRP needs to be enabled, RSTP function for the ports must be disabled first.
150

SNR S2940-8G-v2 Specifications

General

Brand	SNR
Model	S2940-8G-v2
Category	Switch
Language	English