EasyManuals Logo

SNR S2940-8G-v2 User Manual

SNR S2940-8G-v2
420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
SNR S2940-8G-v2 Switch Configuration Guide
Port Channel Configuration
Switch1(Config-If-Ethernet1/1)#exit
Switch1(config)#interface ethernet 1/2
Switch1(Config-If-Ethernet1/2)#port-group 1 mode on
Switch1(Config-If-Ethernet1/2)#exit
Switch1(config)#interface ethernet 1/3
Switch1(Config-If-Ethernet1/3)#port-group 1 mode on
Switch1(Config-If-Ethernet1/3)#exit
Switch1(config)#interface ethernet 1/4
Switch1(Config-If-Ethernet1/4)#port-group 1 mode on
Switch1(Config-If-Ethernet1/4)#exit
Switch2#config
Switch2(config)#port-group 2
Switch2(config)#interface ethernet 1/6
Switch2(Config-If-Ethernet1/6)#port-group 2 mode on
Switch2(Config-If-Ethernet1/6)#exit
Switch2(config)#interface ethernet 1/8-10
Switch2(Config-If-Port-Range)#port-group 2 mode on
Switch2(Config-If-Port-Range)#exit
Configuration result:
Add ports 1, 2, 3, 4 of S1 to port-group1 in order, and we can see a group in on mode is com-
pletely joined forcedly, switch in other ends won't exchange LACP PDU to complete aggregation.
Aggregation finishes immediately when the command to add port 1/2 to port-group 1 is entered,
port 1 and port 2 aggregate to be port-channel 1, when port 1/3 joins port-group 1, port-channel 1
of port 1 and 2 are ungrouped and re-aggregate with port 3 to form port-channel 1, when port 1/4
joins port-group 1, port-channel 1 of port 1, 2 and 3 are ungrouped and re-aggregate with port 4
to form port-channel 1. (It should be noted that whenever a new port joins in an aggregated port
group, the group will be ungrouped first and re-aggregated to form a new group.) Now all four
ports in both S1 and S2 are aggregated in on mode and become an aggregated port respectively.
8.5 Port Channel Troubleshooting
If problems occur when configuring port aggregation, please first check the following for causes.
• Ensure all ports in a port group have the same properties, i.e., whether they are in full-duplex
mode, forced to the same speed, and have the same VLAN properties, etc. If inconsistency
occurs, make corrections.
• Some commands cannot be used on a port in port-channel, such as arp, bandwidth, ip,
ip-forward, etc.
74

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SNR S2940-8G-v2 and is the answer not in the manual?

SNR S2940-8G-v2 Specifications

General IconGeneral
BrandSNR
ModelS2940-8G-v2
CategorySwitch
LanguageEnglish