SNR S2940-8G-v2 Switch Configuration Guide
Web Portal Configuration
Switch(config-if-ethernet1/0/3)#webportal enable
Web portal authentication associates with DHCP snooping binding to use, the configuration is
as follows:
Switch(config)#ip dhcp snooping enable
Switch(config)#ip dhcp snooping binding enable
Switch(config)#interface ethernet 1/0/2
Switch(config-if-ethernet1/0/2)#webportal enable
Switch(config-if-ethernet1/0/2)#ip dhcp snooping binding webportal
55.4 Web Portal Authentication Troubleshooting
When using web portal authentication, the system will show the detailed prompt information if the
operation is wrong.
Web portal authentication is disabled by default. After ensure the configuration is correct, use
debug command and show command to check the relative information, if you can not determine
the cause of the problem, please send the recorded message to technical server center of our
company.
365
To Next Page
Loading...
General