SNR S2940-8G-v2 Switch Configuration Guide
Basic Switch Configuration
Chapter 2
Basic Switch Configuration
2.1 Basic Configuration
Basic switch configuration includes commands for entering and exiting the admin mode, com-
mands for entering and exiting interface mode, for configuring and displaying the switch clock, for
displaying the version information of the switch system, etc.
Command Explanation
Normal User Mode / Admin Mode
enable [<1-15>]
disable
The User uses enable command to step into admin mode from
normal user mode or modify the privilege level of the users. The
disable command is for exiting admin mode.
Admin Mode
config [terminal] Enter global mode from admin mode.
Various Modes
exit Exit current mode and enter previous mode, such as using this
command in global mode to go back to admin mode, and back to
normal user mode from admin mode.
show privilege Show privilege of the current users.
Except User Mode / Admin Mode
end Quit current mode and return to Admin mode when not at User
Mode/ Admin Mode.
Admin Mode
clock set <HH:MM:SS>
[YYYY.MM.DD]
Set system date and time.
show version Display version information of the switch.
set default Restore to the factory default.
write Save current configuration parameters to Flash Memory.
reload Hot reset the switch.
show cpu usage Show CPU usage rate.
show cpu utilization Show current CPU utilization rate.
show memory usage Show memory usage rate.
Global Mode
banner motd <LINE>
no banner motd
Configure the information displayed when the login authentication
of a telnet or console user is successful.
23
To Next Page
Loading...
General