SNR S2940-8G-v2 Switch Configuration Guide
Multi-to-One VLAN Translation Configuration
Chapter 20
Multi-to-One VLAN Translation
Configuration
20.1 Introduction to Multi-to-One VLAN Translation
Multi-to-One VLAN translation, it translates the original VLAN ID into the new VLAN ID according
to user's requirement on uplink traffic, and restores the original VLAN ID on downlink traffic.
Application and configuration of Multi-to-One VLAN translation will be explained in detail in this
section.
The access ports of the switch can not support this function.
20.2 Multi-to-One VLAN Translation Configuration
Multi-to-One VLAN translation configuration task list:
1. Configure Multi-to-One VLAN translation on the port
2. Show the related configuration of Multi-to-One VLAN translation
1. Configure Multi-to-One VLAN translation on the port
Command Explanation
Port mode
vlan-translation n-to-1 <WORD> to <new-vlan-id>
no vlan-translation n-to-1 <WORD>
Configure/delete Multi-to-One
VLAN translation.
2. Show the related configuration of Multi-to-One VLAN translation
Command Explanation
Admin mode
show vlan-translation n-to-1 Show the related configuration of Multi-to-One VLAN trans-
lation.
140
To Next Page
Loading...
General